Npv Configuration Examples; Network Requirements; Configuration Procedure - HP FlexFabric 5700 Series Configuration Manual

Task
Display the login information of NP_Ports.
Display the nodes on downlink interfaces and their
mapped uplink interfaces.
Display the traffic mapping information.
Display status information.

NPV configuration examples

Network requirements

As shown in
Figure 28 Network diagram

Configuration procedure

1. Configure Switch A:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode AdvancedBridge
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchA] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Figure 28, configure the edge switch (Switch A) as an NPV switch to expand the network.
Command
display fc nport [ interface interface-type
interface-number ]
display npv login [ vsan vsan-id ] [ interface
interface-type interface-number ]
display npv login [ vsan vsan-id ] count
display npv traffic-map [ vsan vsan-id ] [ interface
interface-type interface-number ]
display npv status [ vsan vsan-id ]
97