Building A Fabric Statically; Building A Fabric Dynamically - HP FlexFabric 5700 Series Configuration Manual

Building a fabric statically

Tasks at a glance
(Required.)
(Required.)
(Optional.)
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Building a fabric dynamically

Tasks at a glance
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
requests
(Optional.)
(Optional.)
(Optional.)
Enabling or disabling the fabric configuration feature
Setting a fabric name
Configuring an allowed domain ID list
Configuring a domain ID for a switch
Binding the WWN of an N_Port to an FC address
Setting fabric timers
Configuring RSCN aggregation
Configuring and obtaining FC4 information of nodes
Enabling or disabling the fabric configuration feature
Setting the switch priority
Configuring an allowed domain ID list
Configuring a domain ID for a switch
Binding the WWN of an N_Port to an FC address
Setting fabric timers
Configuring fabric reconfiguration
Configuring a VFC interface to reject incoming RCF
Enabling SNMP notifications
Configuring RSCN aggregation
Configuring and obtaining FC4 information of nodes
Remarks
To statically build a fabric, you must
disable the fabric configuration feature.
When statically building a fabric, you must
manually configure the fabric name, and
make sure all switches in the fabric are
configured with the same fabric name.
N/A
When statically building a fabric, you must
manually configure a domain ID for each
switch.
N/A
N/A
N/A
N/A
Remarks
To dynamically build a fabric, you must
enable the fabric configuration feature.
Principal switch selection relies on the
switch priority.
N/A
When dynamically building a fabric, you
can configure desired domain IDs for
switches.
N/A
N/A
N/A
N/A
N/A
N/A
N/A
35