Ricoh NC5006 Operating Instructions Manual page 144

ADJUSTMENT
ADJUSTMENT
~ After finishing to adjust the color balance, image density, or manual focusing, touch the Exit key.
Color Tones In Film Scanning
CJ
c1
Area editing can be selected with the
projector mode, but color balance/image
density control for projector cannot be ad-
justed after area editing job setting is
selected. Make sure to adjust the color
balance and image density before press-
ing the Area Editing
key.
Suppose the copied image are rather
green, there are two ways to adjust the
color tone.
Lighten the Yellow and Cyan
Darken the complementary color
= Magenta
Use these modes when you want to adjust the overall color tone of copies. Also use this
mode when you use negative film, because the color tone of copies varies with the film brand.
You can adjust the tone of copies by adjusting Cyan, Magenta, and Yellow (three basic color- t,
s
a
Adjust the color balance with the in-
crease key and Decrease key.
I
1
Decrease key
5
9
I
Increase
key
Red
Black
I
Blue
You can ad 'ust ;$t ings be low,
or press &l
Cyan ITI ,,, ,?, ,,, ITJ
Density [To,,,,?,,,,
mm
~ The color balance of a film corresponding to one of the three base films can varv depending on the
type of film used and on the photoprocessing center that developed it. The color_ balance settings in
the table below are standard adjustments. Please set them first, and if required, change the settings
from these values,
FUJICOLOR
AGFA XRG-I 00
KODACOLOR
SUPER G-100
SUPER Gold-1 00
Yellow
7 5 5
Magenta 4 4 4
Cyan
3
5 5
-——
10-17