Ricoh NC5006 Operating Instructions Manual page 119

CHANGING DEFAULT SETTINGS
1~[ Auto Reset
Auto Reset
Screen Saver
SADF Auto reset
(for machine with
dual job feeder only)
The copier returns to its initial condition automatically after your job is
finished, The automatic reset time can be set from 10 seconds to 900
seconds, or the function can be turned off.
Cl default: 60 sec.
When the machine does not detect anyone operating it for the selected
time, the touch panel display turns off automatically. This time can be set
from 10 seconds to 900 seconds, or the function can be turned off.
Q default: OFF
In the SADF mode (Semi-Automatic Document Feed mode U= page 4-6
"Set one C)riginal At A Time")? if the next original is not set within the
selected time, the machine will cancel the Semi-Automatic Document
Feed mode automatically. The SADF Auto reset time can be set from 1
to 99 seconds, or the function can be turned off.
Cl default: 5 sec.
[ 2 [ Set Operation Modes
Maximum copy input
number
3
Side Full Image
Auto Tray Switching
Panel beeper
Editor Grid Display
(for machine with
display editor only)
The maximum copy quantity can be set from 1 to 99.
~ default: 99
In the default setting, narrow margins on all four sides will not be copied
as shown in the illustration.
OFF ~ Paper feed direction ON
D
default: OFF
Cl You cannot cancel the leading edge margin.
If you load paper of the same size and in the same direction in two or
more paper trays, the machine automatically shifts to another tray when
the tray in use runs out of paper.
Q default: ON
Cl By-pass feed tray cannot be used for Auto Tray Shifting,
The bee er (key tone) can be set to on or off.
P Cl defau t: ON
You can set the grid snap on or off in the display editor.
The rids ma help you to mark a right angle shape.
Lld#ault: O#F
I 3 I Set Bypass Paper Size
If you load non-standard paper in the by-pass feed tray, the machine cannot detect the paper
size and direction and the copied image might not be correctly positioned on the copy paper.
One non-standard paper size and direction data is always specified in the user tool, and if
the non-standard paper size you are going to use is different from this, change the paper size
and direction data with this user tool to make a correct copy. (Horizontal direction: 148-432
mm or
5.8"-
17.0",Vertical
direction: 100-297 mm or 3.9"-11.7"
)
8-3