Ricoh NC5006 Operating Instructions Manual page 136

PREPARING FOR COPYING
Setting Films In The Holder (If Needed)
~
Check which type of holder you should use.
Slide Holder/Glass Mount Film Holder
D
The slide holder is covered with glass. Set the mount films in the slide holder.
CJThe glass mount film holder is not covered with glass.
the glass
mount
film holder.
IJ Positive film is usually set in a slide mount or glass mount.
in the film strip holder (= Film Strip Holder).
1.
Open the cover of the slide holder or
glass mount film holder, and set the
slides in the holder one by one.
~
Make the front side of the film face down
when setting in the slide holder or glass
mount film holder.
0 When setting in the slide holder, make
sure that all slides must be aligned to the
glass of the slide holder cover.
2. Close the holder and lock it as shown
in the illustration.
Film Strip Holder
U Negative film usually come in strips.
!3 Follow this procedure for positive strip film as well.
1. Open the film strip holder. Put the
front side of the film face down and set
it in the film strip holder.
Set the glass mount films (covered by glass) in
If you use positive film not set in a mount, set it
b up
w
>-
Front
10-9