Ricoh NC5006 Operating Instructions Manual page 148

HINTS
HINTS
1. If the color balance k improper.
n If the color density leans to red or blue, or isn't properly balanced, perform the color
density adjustment, and the color balance adjustments for Yellow, Magenta, and
Cyan (= page 10-18).
2.
If the film you want to copy does not match the types of base film included.
D If you do not plan on copying from
this type of film often, use an unex-
posed frame of the same film strip,
if available, when performing shad-
ing.
n If you plan on copying from this
type of film often, make a base
slide using an unexposed,
developed frame of the film.
n If you have no blank unexposed
frame of the same type of film, you
can use an unexposed frame from
film produced by the same com-
pany, but the colors might differ a
bit.
3. If the copy image is out of focus
part Mount
IJ Check if the image on the film is focused or not. If it is, make sure the film is correctly
set in the holder.
n If you reset the film correctly in the holder and the image is still out of focus, or if you
use a different image, and the copy image is out of focus in every case, please call
your service representative.
IJ You can adjust the focus manually with the focusing lever (= page 10-18).
4. If the edge of the original image does not appear on the copy,
~ Check the size of the area that can be copied (I= page 10-15).
n When setting film in the holder, make sure to position the desired frame properly.
a To extend the area that can be copied, use the glass mount film holder and focus
manually.
10-21