Ricoh NC5006 Operating Instructions Manual page 139

SHADING
Before making copies, you must peflorm shading to get the projector to register the condition
of the film. This way, the projector can adjust the light intensity automatically while copying.
II
35mm Slides
Positive (Slide Holder/Glass Mount Film Holder/Film Strip Holder)
1.
2.
3.
4.
Set the film (slide or strip) in the holder.
(= page 1O-9)
Open the film cover and insert the "P"
(Positive) filter (II= page 10-7) in the left
slot as shown in the illustration.
IJ
Be
carefulto insertthe filteras
shown, not
the other way around.
Cl Before going to the next step, make sure
that the fresnel lens is lowered in position.
Touch the
Shading key.
Cl
The copier will start shading automat-
ically.
Check
if the film is correctly set (I=
page 10-9) in the holder. While press-
ing the holder lever to the right, insert
the holder slightly in the right slot.
5. Adjust the holder by sliding it up and
down to position the correct frame for
copying.
12!u!El
10-12