When A Message Is Displayed; When A Message Is Displayed On The Control Panel - Ricoh Aficio IS 2425 Operating & Troubleshooting Instructions

Troubleshooting When Using the Scanner Function

When a Message Is Displayed

This section describes likely causes of and possible solutions for error messages
that might appear on the machine's control panel.

When a Message Is Displayed on the Control Panel

This section describes causes and remedies if an error message appears on the
display of the control panel.
Important
❒ If a message not described here appears, act according to the message. For in-
formation about how to turn off the main power switch, see "Turning Off the
Main Power", About This Machine.
Message
5
Connection with
LDAP server has
failed. Check the
server status.
LDAP server au-
thentication has
failed. Check the
settings.
The destination
list has been up-
dated. Specified
destination(s) or
sender's name has
been cleared.
Updating the des-
tination list has
failed. Try
again?
Updating the des-
tination list...
Please wait.
Specified desti-
nation(s) or
sender's name has
been cleared.
62
Cause
A network error has oc-
curred and connection
has failed.
The user name and pass-
word differ from those set
for LDAP Authentication.
A specified destination
or sender's name was
cleared when the desti-
nation list in the delivery
server was updated.
A network error has oc-
curred.
The destination list is be-
ing updated.
Solution
Try the operation once more. If the mes-
sage is still shown, the network may be
crowded. Check the information of Sys-
tem Settings. See "System Settings",
General Settings Guide.
Make settings correctly for the user
name and the password for LDAP serv-
er authentication.
Specify the destination or sender's name
again.
Check whether the server is connected.
If a destination or sender's name was al-
ready selected, re-select it after this mes-
sage disappears.