Table of Contents
Advertisement
If Your Machine Does Not Operate As You
Want
When a Message Is Displayed
The following chart contains explanations of common messages. If other mes-
sages are displayed, then follow the instructions as displayed.
Note
❒ For messages not listed here, see "Troubleshooting" General Settings Guide.
Message
Cannot detect
original size.
Check original
orientation.
Check paper size.
Rotate Sort is not
available with
this image size.
Cannot punch paper
of this size.
It is over sta-
pling capacity.
4. Troubleshooting
Causes
An irregular original is
placed. See p.12 "Sizes dif-
ficult to detect".
Original is not placed.
There is no copy paper in
the same orientation as the
originals.
An irregular paper size is
set.
A paper size for which Ro-
tate Sort is not available is
selected.
The Punch function cannot
be used with paper size se-
lected.
The number of sheets per
set is over the staple capac-
ity.
Solutions
Place custom size originals on the
exposure glass. See p.14 "Placing
Originals on the Exposure Glass".
Enter the horizontal and vertical
size of the custom size original. See
p.14 "Placing Originals on the Expo-
sure Glass".
Select paper manually, not with the
Auto Paper Select function.
Do not use the Auto Reduce/En-
large function.
Place originals.
Place the original in the same orien-
tation as the copy paper.
Press the { { { { Start} } } } key and copying
will start on the selected paper.
Select a proper paper size. See p.130
"Sort, Rotate Sort, Stack".
The following paper sizes are avail-
able for Punch mode: A3L, B4
JISL, A4KL, B5 JISKL, A5K,
1
"×14" L, 8
11"×17"L, 8
/
2
KL. Select one of these sizes.
Check the stapler capacity. See p.132
"Staple".
1
/
"×11"
2
95
Advertisement
Table of Contents
