Ricoh Aficio IS 2425 Operating & Troubleshooting Instructions page 14

When the Machine Does Not Operate As Wanted
Problem
The main power indica-
tor continues blinking
and does not turn off
1
when pressed.
Original images are
printed on the reverse
side of the paper.
Misfeeds occur frequently. The tray's side guides are
Misfeeds occur frequently. The tray's end guide is
Misfeeds occur frequently. You may have loaded pa-
An error message re-
mains, even if misfed pa-
per is removed.
An error message re-
mains, even if consuma-
bles are replaced and/or
misfed paper is removed.
Cannot print in duplex
mode.
Cannot print in duplex
mode.
6
Cause
This occurs in the follow-
ing cases:
• The exposure glass
cover or ADF is open.
• The machine is com-
municating with ex-
ternal equipment.
• The hard disk is active.
You have loaded the pa-
per incorrectly.
not locked.
not set properly.
per of a size not shown
on the paper size selector.
When a misfeed message
appears, it remains until
you open and close the
cover as required.
This may occur if the
HDD is not installed.
You cannot use paper in
the bypass tray for du-
plex printing.
[1 Sided Copy] is selected
for Paper Type: Tray 1-4.
Solution
Close the exposure glass cover or ADF,
and check if the machine is communicat-
ing with a computer.
Load paper correctly. Load paper into
Tray 1-4 with the print side up, and into
the LCT or bypass tray with the print
side down. See p.76 "Orientation-fixed
paper or two-sided paper".
• Remove the paper. See p.89 "Remov-
ing Jammed Paper".
• Check that the side guides are
locked. See p.77 "Changing the Pa-
per Size".
• Remove the paper. See p.89 "Remov-
ing Jammed Paper".
• Check that the end guide is set prop-
erly. See p.77 "Changing the Paper
Size".
• Remove the paper. See p.89 "Remov-
ing Jammed Paper".
• When using paper of a size that can-
not be detected automatically, use
Tray Paper Settings to set the paper
size. See "Tray Paper Size: Tray 1-4",
General Settings Guide and "Copy
Paper", About This Machine.
Clear misfed paper, and then open and
close the front cover. see p.89 "Remov-
ing Jammed Paper".
Press the {Start} key.
For duplex printing, select Tray 1-4 in
copier mode or with the printer driver.
Select [2 Sided Copy] for Paper Type: Tray
1-4. See "Paper Type: Tray 1-4", General
Settings Guide.