Complete The Parts Replacement - Lenovo ThinkSystem SR860 Maintenance Manual

Figure 157. PCIe adapter installation
After installing the PCIe adapter, complete the following steps:
1. Install the top cover (see "Install the top cover" on page 148).
2. If the server is installed in a rack, reinstall the server into the rack.
3. Power on the server and any peripheral devices.

Complete the parts replacement

Use this information to complete the parts replacement.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server. Refer to the cable connecting and routing information
for each component.
3. If you have removed the server cover, reinstall it. See "Install the top cover" on page 148.
4. Reconnect external cables and power cords to the server.
Attention: To avoid component damage, connect the power cords last.
5. Update the server configuration.
• Download and install the latest device drivers:
• Update the system firmware. See "Firmware updates" on page 5.
• Update the UEFI configuration.
• Reconfigure the disk arrays if you have installed or removed a hot-swap drive or a RAID adapter. See
the Lenovo XClarity Provisioning Manager User Guide, which is available for download at:
datacentersupport.lenovo.com
166
ThinkSystem SR860 Maintenance Manual
http://datacentersupport.lenovo.com
http://