Operator Panel Tray Assembly And Front Operator Panel Replacement - Lenovo ThinkSystem SR860 Maintenance Manual

Operator panel tray assembly and front operator panel replacement

Use this procedure to remove or install the operator panel tray assembly and the front operator panel.
Remove the operator panel tray assembly
Use this procedure to remove the operator panel tray assembly.
Before removing the operator panel tray assembly:
1. Read the safety information and installation guidelines (see "Safety" on page iii and "Installation
Guidelines" on page 59).
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page 10).
3. If the server is installed in a rack, remove the server from the rack.
4. Remove the top cover (see "Remove the top cover" on page 146).
5. Remove the PCIe expansion tray (see "Remove the PCIe expansion tray" on page 149).
6. Remove the chassis air baffle (see "Remove the chassis air baffle" on page 65).
To remove the operator panel tray assembly, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube: https://www.youtube.com/watch?v=pIb0bIyfkDY&=PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
• Youku:
http://v.youku.com/v_show/id_XMzMyODU3NTY2NA==.html?spm=a2hzp.8253876.0.0&f=51276390
Step 1. Remove the fan cage assembly (see "Remove the fan cage assembly" on page 71).
Step 2. Disconnect USB cables and front operator panel cable from the system board.
Figure 83. USB 2.0 cable and front operator panel cable
Table 48. USB 2.0 cable and front operator panel cable
1
USB 2.0 cable
Note: Make sure the USB 3.0 connector stays vertical when being removed from the system
board.
92
ThinkSystem SR860 Maintenance Manual
2
Front operator panel cable