Advertisement
KC9111/KC9111-2 & KC9321/KC9321-2 INSTALLATION
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
6) Install the Key Cylinder:
Install .050" cylinder washer.
•
IMPORTANT: A .050" cylinder washer must be used IN ALL CASES,
regardless of the key cylinder length.
If you are installing a cylinder that is longer than 1-1/8", you
•
must also install a blocking ring (see Table 1: Blocking
Rings, on page 8).
A simple formula for determining blocking ring thickness is:
Blocking ring thickness = length of cylinder minus 1-1/8"
If not already done, install cam onto cylinder. Cam must be clo-
•
ver leaf design (see Table 2: Recommended Cams, on page 8).
Tilt top of trim down at a sharp angle.
•
Screw in key cylinder until it stops. Use mechanical key as a han-
•
dle for turning if necessary.
Key Cylinder Length
•
•
•
•
Cylinder/Core
•
Standard Mortise Cyl
•
Standard Mortise Cyl
•
Interchangeable Core
7) Align Key Cylinder:
After screwing it all the way in, back off on key cylinder
•
(no more than one turn) until key is at the bottom. If key
cylinder has a logo (a), logo should be at the top of key
cylinder.
57040-E
Table 1: Blocking Rings
1-1/4"
1-3/8"
1-1/2"
1-5/8"
Table 2: Recommended Cams
Blocking Ring (Schlage P/N; XXX = finish)
1/8" (36-079-012-XXX)
1/4" (36-079-025-XXX)
3/8" (36-079-037-XXX)
1/2" (36-079-050-XXX)
Schlage Type
Everest
Classic
IC Cam
Page 8
Part Number
L583-153
L583-254
L583-255
04-2007
a
Advertisement
