Advertisement
KC9111/KC9111-2 & KC9321/KC9321-2 INSTALLATION
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
If your trim has a key cylinder already installed, skip to Determine Hand: on page 12. Other-
wise, continue with Loosen the Baseplate Screws: on this page.
1) Loosen the Baseplate Screws:
IMPORTANT: Do not remove any of the screws in the fol-
lowing step or it will be difficult to reinstall them.
Using a small Philips head screwdriver, loosen
•
screws a & b in baseplate, around key cylinder
hole, one turn.
NOTE: Screws a, b, c & d are set at the factory.
Screws a & b are tightened and screws c & d are left loose.
2) A Key Cylinder That Is At Least 1-1/8" Long Must Be Installed:
> The key cylinder that you install must be 1-1/8" long or longer.
>>>> Do not attempt to install a key cylinder that is shorter than 1-1/8"
> The two illustrations below show the difference between a 1" and a 1-1/8" key cylinder.
57040-E
1" long key cylinder.
DO NOT ATTEMPT TO INSTALL A 1"
LONG KEY CYLINDER.
1-1/8" long key cylinder
ONLY INSTALL A KEY CYLINDER
THAT IS AT LEAST 1-1/8" LONG.
Page 6
d
c
b
a
04-2007
Advertisement
