KC9111/KC9111-2 & KC9321/KC9321-2 INSTALLATION
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
36) Tighten Top Mounting Screw:
Using a ball-end, 1/8" Allen wrench, partially tighten
•
the top screw in trim.
IMPORTANT: Do not completely tighten the top screw.
Leave loose.
37) Remove Battery Cover:
If not already done, insert key into cylinder and turn
•
it counterclockwise.
Using a small, flat blade screwdriver, loosen the
•
battery cover screw (a) ONLY TWO TURNS
COUNTERCLOCKWISE.
Slide off battery cover (b) from bottom.
•
38) Install Lower Mounting Screws:
Remove battery pack (a).
•
Install and completely tighten both lower mounting screws (b) and
•
(c) located within battery compartment.
Finish tightening top mounting screw.
•
57040-E
Page 22
a
b
04-2007
a
b
c
a