KC9111/KC9111-2 & KC9321/KC9321-2 INSTALLATION
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
18) Remove Interface's Hook Assembly:
Lift off hook assembly (a) from interface.
•
19) Flip Hook Over:
Remove pin (a) from hook (b).
•
Flip hook over.
•
Insert pin back into hook.
•
Install hook assembly back onto inter-
•
face.
Pin (c) on interface must go through
•
slot in hook
20) Install New Retaining Ring-RHR:
Photo on right shows an interface that will be used in
•
a RHR installation. Observe direction of "finger" (a)
on hook assembly.
Push new retaining ring (included in screw pack)
•
back onto pin.
57040-E
a
Page 14
a
c
b
a
04-2007