Advertisement
KC9111/KC9111-2 & KC9321/KC9321-2 INSTALLATION
3) Make Room for Key Cylinder:
Due to the diameter of the key cylinder, it is necessary
to have dead latch (a) placed out of the way when
installing the key cylinder. Therefore...
Using your finger or a pair of needle-nose
•
pliers, push dead latch towards the top end
of trim as indicated by arrow in photo.
NOTE: As indicated by arrow in photo, you'll notice
that when you push the dead latch forward, it will
swing a little bit in a counterclockwise direction.
4) Hold Dead Latch in Place:
To insure that dead latch is placed far enough out
of the way to allow key cylinder to be threaded in
properly:
Insert a finger into key cylinder hole and
•
hold dead latch firmly in place.
Carefully turn the trim over while keep-
•
ing the dead latch in position.
5) Verify Placement of Dead Latch:
Two holes on dead latch (a) should be showing within
the two holes (b) in baseplate.
57040-E
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
Fig. 1
Page 7
b
b
a
04-2007
a
Advertisement
