Advertisement
KC9111/KC9111-2 & KC9321/KC9321-2 INSTALLATION
Installing the KC9111/KC9111-2 or KC9321/KC9321-2
21) Install New Retaining Ring-LHR:
Photo on right shows an interface that will be used in
•
a LHR installation. Observe direction of "finger" (a)
on hook assembly.
Push new retaining ring (included in screw pack)
•
back onto pin.
If you are installing a KC9111/KC9111-2, continue with, Install the Lever: on page 15. Other-
wise, skip to, What To Do With the Adams Rite® Product: on page 16.
22) Install the Lever:
Determine correct orientation for door and lock hand and slide lever
•
onto shaft accordingly.
NOTE: A RHR installation is shown in the photo on the right.
Using a 5/64" hex wrench, tighten the set screw.
•
IMPORTANT: After set screw has been completely tightened, top of set
screw should be at or a little bit below surface of lever. If not, check to
insure that lever is pushed completely over shaft.
23) Install the Lever Cover:
Place lever cover onto inside of lever.
•
57040-E
Page 15
a
04-2007
Advertisement
