Furuno SC-130 Operator's Manual page 78

2. OPERATION
8. Select [ATTITUDE SETTING], then press the ENT key. The [SIMULATION(ATTI-
TUDE) SETTING] window appears.
No.
1 [ATTITUDE]
• [HDG AMPLITUDE]
• [HDG ANGULAR RATE]
• [PITCH AMPLITUDE]
• [PITCH ANGULAR RATE]
• [ROLL AMPLITUDE]
• [ROLL ANGULAR RATE]
2 [HEAVE]
• [AMPLITUDE]
• [FREQUENCY]
9. Referring to the figure and table above, select a parameter to set for the simula-
tion, then press the ENT key. A settings pop up window appears.
10. Press the CursorPad to move the cursor and adjust the settings for the selected
parameter. When the settings for the selected parameter are complete, select EN-
TER, at the bottom of the window, then press the ENT key. The [SIMULA-
TION(ATTITUDE) SETTING] window appears.
11. When all parameter settings are complete, select ENTER, at the bottom of the
[SIMULATION(ATTITUDE) SETTING] window, then press the ENT key. The
[SIMULATION] menu appears.
12. Select [SIMULATION], then press the ENT key. The start/stop options window ap-
pears.
13. Select [START]. A confirmation window appears. Select [YES] to start the simu-
lation, or select [NO] to cancel.
If you select [YES], the system restarts. When the restart is completed, the system
operates in simulation mode and the simulation indicator is shown at the top-right
of the display.
How to stop the simulation
You can stop the simulation at any time from the menu.
1) Referring to the steps 1 to 3 of the above procedure, open the [SIMULATION] menu.
2) Select [SIMULATION], then press the ENT key. The start/stop options window ap-
pears.
3) Select [STOP]. A confirmation window appears. Select [YES] to start the simulation,
or select [NO] to cancel.
If you select [YES], the system restarts. When the restart is completed, the system
operates in normal mode and the simulation indicator is not shown at the top-right
of the display.
2-36
Menu item Description
Attitude settings for heading, pitch and roll.
• Sets the heading angle.
• Sets the rate at which the heading changes.
• Sets the pitch angle.
• Sets the rate at which the pitch changes.
• Sets the roll angle.
• Sets the rate at which the roll changes.
Settings for heave.
• Sets the distance for heave.
• Sets the frequency (Hz) for heave.