Furuno SC-130 Operator's Manual page 18

1. INSTALLATION
200
160
160
300
3. Secure the unit to the platform with four sets of M10 hex. nuts, spring washers and
flat washers (all included as installation materials) with 20 ±2 Nm torque.
Note 1: Take care not to crush the cabling when mounting the antenna to the plat-
form.
Note 2: Take care not to cover the breathing hole on the antenna.
4. Coat the exposed parts of the nuts, bolts and washers with the Adhesive TB5211
(included) to prevent corrosion.
Mounting platform
5. Connect the SC-703 cable to the cable from the SC-701, then waterproof the con-
nection (see section 1.5.2 for the waterproofing procedure).
6. Remove the double-sided tape from the optional bird-repellent fixtures, then at-
tach to the antenna cover. Coat around the bird-repellent fixtures with the Adhe-
sive TB5211 (included).
7. Secure the cables to the mast (or superstructure) with cable ties, at regular inter-
vals.
1-4
Fixing hole (ø11 mm)
5 mm to 15 mm
Flat washer
Spring washer
Hexagonal nut (M10)
Antenna base Antenna base
Flat washer
Spring washer
Positioning the antenna cable
(Stern view)
BOW
Indent Indent
Cable Cable
Bolt
Coat with adhesive.
Hex nuts