How To Connect The Junction Box (Sc-701) - Furuno SC-130 Operator's Manual

Antenna
Unit
1.5.5

How to connect the Junction Box (SC-701)

The Junction Box (SC-701) has two rows of cable entrances for connection. The fol-
lowing figure and table show the internal connection points for the SC-701 and the rec-
ommended cable entrance for each connection (based on a configuration which uses
all connections). The tables on the following pages show the pin connections for each
WAGO connector.
J4: LAN_CONV assy. J4: LAN_CONV assy.
LAN connections LAN connections
J3: Antenna unit J3: Antenna unit
J2: Service/maintenance only J2: Service/maintenance only
J1: Network J1: Network
Note 1: LAN cable recommended entrances should be used to prevent undue stress
to the LAN cables. The power and DISP cable must be passed through their recom-
mended entrance to prevent damaged to the cabling.
Secure and protect the joint of TNC connectors.
Coaxial cable (existing) Coaxial cable (existing)
(For L-type or when (For L-type or when
using OP20-47) using OP20-47)
1 1 2 2
Top row Top row
Bottom row Bottom row 10 11 11 12
9 9 10
J2: For Factory setting (unused) J2: For Factory setting (unused)
USB port USB port
TB10 terminal TB10 terminal
3 3 4 4 5 5 6 6 7 7 8 8
12 13 13 14 14 15 15
1. INSTALLATION
Junction
Box
Fuse for DISP Fuse for DISP
connection connection
Fuse for Fuse for
SC-701 SC-701
Power Power
terminals terminals
(TB1) (TB1)
Power Power
cable cable
entrance entrance
Ground Ground
terminal terminal
1-17