How To Acknowledge Alerts; How To Enable/Disable The Aural Alert (Non-Imo Type Only) - Furuno SC-130 Operator's Manual

2. OPERATION
2.11.1

How to acknowledge alerts

There are two methods by which you can acknowledge an alert.
How to acknowledge an alert from the display unit (All alert modes)
Press the ACK key to acknowledge the alert.
How to acknowledge an alert remotely (LEGACY alert mode only)
The [REMOTE ACK I/F] setting sets the behavior of external equipment which can ac-
knowledge alerts. To use this function, the [ALERT MODE] must be set to [LEGACY]
at installation. (Consult your dealer to change this setting.)
To set remote acknowledge, do the following:
1. Open the [MENU].
2. Select [ALERT], then press the ENT key.
3. Select [REMOTE ACK I/F], then press the ENT key.
4. Select the appropriate setting, then press the ENT key.
Setting
[ACK]
[BUZZER STOP]
5. Close the [MENU].
Refer to the operator's manual for the external equipment for alert acknowledgment
procedures.
2.11.2

How to enable/disable the aural alert (Non-IMO type only)

This setting is only available for non-IMO types.
1. Open the [MENU].
2. Select [ALERT], then press the ENT key.
3. Select [SOUND], then press the ENT key. An options pop up window appears.
4. Select the appropriate option, then press the ENT key.
Option
[OFF]
[SHORT]
[LONG]
[CONTINUOUS] Release a continuous beep when an alert is triggered.
5. Close the [MENU].
2-16
External equipment can acknowledge alerts.
External equipment can stop aural alerts, but cannot acknowledge
alerts.
Description
Disable aural alerts.
Release two short beeps when an alert is triggered.
Release three long beeps when an alert is triggered.
Description