Service manual
Replacing the LED light source
1.
Remove the frost and prism module. See
"Removing the frost and prism module" on page
17.
2.
Remove the gobo and animation module. See
"Removing the gobo and animation module" on
page 20.
3.
Remove the color flag module. See "Removing
the color flag module" on page 24.
4.
Remove the four Torx10 screws (1).
NOTE! To remove the upper screws, use a Torx10
screwdriver. To remove the lower screws, use
either a socket wrench, a ratchet wrench with a
Torx10 bit or a 90-degree adaptor for Torx10 bit.
Finally, you can also remove the front lens and the
lens assembly to access the LED light source.
5.
Remove the two connectors (2).
6.
Replace the LED light source.
7.
Follow the procedure in reverse order.
Removing the rear cover
1.
Remove the 7 Hex5 screws (1).
2.
Follow the procedure in reverse order.
Exterior Projection 500 - Revision A, 12-19-2017
2
Figure 64: Replacing the LED light source
Figure 65: Replacing the rear cover
1
1
1
27 of 32