Section 5 Connection Procedures; Connecting User System Interface Board To User System; Installing Ic Socket - Renesas FP-144F User Manual

5.1

Connecting User System Interface Board to User System

Always switch OFF the user system and the emulator
product before the USER SYSTEM INTERFACE BOARD
is connected to or removed from any part. Before
connecting, make sure that pin 1 on both sides are correctly
aligned. Failure to do so will result in a FIRE HAZARD and
will damage the user system and the emulator product or
will result in PERSONAL INJURY. The USER PROGRAM will
be LOST.
To connect the cable head to the user system, follow the instructions below.
5.1.1

Installing IC Socket

Solder the IC socket for an FP-144F package to the user system.
Be sure to completely solder the leads so that the solder
slops gently over the leads and forms solder fillets. (Use
slightly more solder than the MCU.)
8

Section 5 Connection Procedures

WARNING
CAUTION