Table of Contents
Advertisement
2.1
Connecting the User System Interface Board to the User System
Always switch OFF the user system and the emulator
product before the USER SYSTEM INTERFACE BOARD
is connected or removed. Before connecting the two, make
sure that pin 1 on both sides are correctly aligned. Failure to
do so will result in a FIRE HAZARD and will damage the
user system and the emulator product or will result in
PERSONAL INJURY. The USER PROGRAM will be LOST.
To connect the emulator to the user system, ensure that
the SW1 jumper pin is inserted to [USER-ON].
Failure to do so will damage the emulator product, user
system interface board, and user system.
Section 2 Connection Procedures
WARNING
CAUTION
Section 2 Connection Procedures
Rev. 2.00 Sep. 08, 2008 Page 3 of 30
REJ10J1868-0200
Advertisement
Table of Contents
