Section 2 Connection Procedures; Connecting The User System Interface Board To The User System; Installing The Ic Socket - Renesas H8SX/1651 User Manual

2.1

Connecting the User System Interface Board to the User System

Always switch OFF the user system and the emulator
product before the USER SYSTEM INTERFACE BOARD
is connected or removed. Before connecting the two, make
sure that pin 1 on both sides are correctly aligned. Failure to
do so will result in a FIRE HAZARD and will damage the
user system and the emulator product or will result in
PERSONAL INJURY. The USER PROGRAM will be LOST.
To connect the cable head to the user system, follow the instructions below.
2.1.1

Installing the IC Socket

After checking the location of pin 1 on the IC socket fasten it to the user system before soldering.
After confirming the location of pin 1 on the IC socket,
apply epoxy resin adhesive to the end of the four projections
at the bottom of the IC socket, and fasten it to the user
system.

Section 2 Connection Procedures

WARNING
CAUTION
Section 2 Connection Procedures
Rev. 2.00 Sep. 08, 2008 Page 3 of 20
REJ10J1394-0200