Crestron Connected; Control System - Crestron AM-200 Deployment Manual

Crestron Connected

AirMedia devices can control any Crestron Connected compatible display. When
launching the application, a "power on" command is sent to the display, eliminating the
need for a remote control or the press of a power button.
To use the Crestron Connected feature, the user provides the display's IP address or IP
ID. When a user connects to the AirMedia device, a command is issued to turn on the
display. After the last user disconnects from the AirMedia device, a command is issued to
turn off the display.
For more information on Crestron Connected devices, refer to
https://www.crestron.com/en-US/Products/Crestron-Connected-Devices

Control System

The AM-100, AM-101, and DMPS3 can integrate with 3-Series® Crestron control systems
for complete room control. When a Crestron control system is used, lights, display,
HVAC, shading, and virtually any other device in the room can be controlled. The AM-200
and AM-300 have a join interface planned for a future firmware release.
Additionally, the control system can implement Simple Network Management Protocol
(SNMP) to integrate with existing IT management tools. The device parameters can be
set and monitored by a Crestron control system, as shown in the Device Parameters
table below.
Device Parameters
NAME
Status
Number of Users
Connected
Device Access Code
Projector Connected
Status Text
Device Parameters Table (Type Column) Key
CRESTRON TYPE
Digital
Analog
Serial
Crestron Fusion® software can also provide an alternative monitoring mechanism to
SNMP. For more information on Crestron Fusion software, refer to
www.crestron.com/en-US/Products/Featured-Solutions/Crestron-Fusion.
Deployment Guide – DOC. 7693K
ACCESS TYPE
Read Analog
Read Analog
Read Analog
Read/Write Analog
Read Serial
STANDARD TYPE
Boolean
16-bit integer
String (maximum length 255 bytes)
FUNCTION
Reports the status of the device
Indicates the number of users currently connected
Sets the device access code
NOTE: The input sets the current code and is only
valid when the device code is in Fixed mode
(configured through the device's web pages).
Reports the status of a connected projector
Valid Values:
0 = Not connected
1 = Connected
Returns the status of the device as a string for display
AirMedia Presentation Gateway • 15