Appendix A-4: Controller Tab - HighPoint RocketRAID 4520 User Manual

Setting Boot Array
1. Navigate to the array panel (Press ALT + W, then press 2)
2. Select desired array
3. Press ALT + A to open array tab
4. Press Set Boot
5. Window will close, reboot to confirm

Appendix A-4: Controller Tab

Information
Setting...
Controller > Setting Information
Enable Audible Alarm
Enable Staggered Spin up
Provides certain controller information:

Product ID

PCI Location
 IOP Model

SDRAM Size

Firmware Version

Battery Installed

Battery MB Installed

Serial Number

CPU Temperatures (Celcius)

Board Temperature (Celcius)

Controller voltage levels
Configures certain settings:

Enable audible alarm
 Enable Staggered spin up

Spin down idle disk (minutes)

Enable automatic rebuild

Continue Rebuilding on error
 INT13 support

Use single BCV entry

Stop on error
Enables/Disables the RocketRAID
controller alarm
(Default: Disabled) Enabling this setting
will force the card to power on each hard
disk sequentially (2 seconds between
disks). Check with your disk manufacturer
if your drive supports this feature.
60