Clutch Discs, Pressure Plate; Clutch Housing - SHERCO 250 SE-R 2017 Workshop Manual

REASSEMBLY THE ENGINE
❱❘ Clutch discs, pressure plate
- Apply oil to the clutch release bearing
assembly [1] and install in the primary shaft.
- Prior to installation lubricate the friction discs.
- Install a friction disc and then alternate,
friction/steel until 8 friction and 7 steel discs
are installed.
- Install the pressure plate, the spring cups, the
springs and the screws.
- Tighten the screws to 10Nm using a cross
pattern for tightening.
❱❘ Clutch housing
- Check to make sure that the two locating
dowels are in place in the housing.
- Install the housing gasket and retain it with a
little grease.
- Install the water pump shim washers [2] use a
little grease to retain them.
- Install the clutch housing, make sure that the
water pump drive gear engages the crankshaft
gear; you may have to rotate the gear to get it
to engage.
- Install the M6 screws and tighten to 10Nm,
except for the M6X12 which is tightened to
6Nm.
CAUTION
Install a new gasket on the M6X50 drain plug
screw as well as the M6X12 screws.
- Check to make sure that everything turns
smoothly.
40
250-300 SE-R
2