Checking The Charging System; Static Control Values (Engine Off) 250 Se-R/300 Se-R; Dynamic Control Values - SHERCO 250 SE-R 2017 Workshop Manual

CHECKING THE CHARGING SYSTEM

❱❘ Static control values (engine off) 250 SE-R/300 SE-R
- Battery voltage > 12.5V
- Resistance value of the stator windings: Measure the resistance between each winding.
Y1-Y2
Y2-Y3
Y1-Y3
Check to make sure that there is no continuity between the windings and the mass of the bike.
- Resistance at the Pick UP sensor (Speed sensor):
Red ~ Green 100 Ω±20% (at 20°C)
- High tension coil
Primary coll 0.30 Ω±15% (at 20°C)
Secondary coll 6.3 Ω±20% (at 20°C)
❱❘ Dynamic control values
- Voltage regulator:
Alternating (AC 200V class)
At idle 22V ±2V
T 6000 RPM: 77V±3V
Continuous
On the output regulator (20V continuous)
At 4000 RPM: 14.6V + Red/White, - Green
48
0.46Ω±20% (à 20°C)
250-300 SE-R