Table of Contents
Advertisement
ENGINE REASSEMBLY
❱❘ Clutch discs pressure plate
[1]
• Oil the push finger
shaft.
• Prior to the assembly step, oil the lined discs.
• Begin with a lined disc. The 8 lined discs and the
7 smooth discs are positioned in an alternating
pattern.
• Install the pressure plate along with the springs, the
spring plates and the screws.
• Tighten the screws to 10 Nm in a cross pattern.
❱❘ Clutch casing
• Verify whether the two centering bushings are
indeed well installed.
• Introduce the casing joint and hold it in place
with a bit of lubricant.
• Stick the water pump set ring
lubricant.
• Present the clutch casing while ensuring that the
water pump assembly has been properly
installed. The connecting rod assembly needs
to be rotated so that the water pump can mesh
at the end of the crankshaft.
• Install the M6 hex sprocket screws and tighten
to 10 Nm.
Verify that all shafts rotate without encountering any hard point
•
and insert it onto the main
[2]
with a bit of
CAUTION
Install a new joint on the M6X40 screw and on
the coolant drainage screw.
1
2
.
30
Advertisement
Table of Contents
