Selector Mechanism - SHERCO 250 SE-R 2017 Workshop Manual

REASSEMBLY THE ENGINE
❱❘ Selector mechanism
- Place the spring in the housing with the bent
portion facing up.
- Install the spacer, the locking pin and the
washer, apply blue thread locker to the M6X20
bolt and assemble everything.
- Hook the spring on the lever. The other end of
the spring should be on the housing.
- Install the star shaped selector drum.
- Place the roller of the interlock mechanism on
the selector drum.
- Apply blue thread locker on the screw and
install it in the selector drum.
- Apply grease to the gear selector shaft and
install it in the needles bearings in the case,
remember to install the shim.
- When the selector arm contacts the star
shaped drum, retract it so that the shaft can be
fully inserted.
- Check to make sure the ends of the spring are
in contact with the case as shown.
- Temporarily install the gear shift lever on the
selector shaft and make sure that the
transmission gears shift correctly and that
when the gears are shifted the output shaft
turns. Remove
38
the gear shift lever.
250-300 SE-R