Clutch Discs, Pressure Plate; Clutch Casing - SHERCO 125 SE-R 2017 Workshop Manual

I
I
ENGINE REASSEMBLY
❱❘ Clutch discs, pressure plate
- Oil the push finger [1] and insert it onto the main
shaft.
- Prior to the assembly step, oil the lined discs.
- Begin with a lined disc. The 8 lined discs and
the 7 smooth discs are positioned in an
alternating pattern.
- Install the pressure plate along with the springs,
the spring plates and the screws.
- Tighten the screws to 10 N-m in a cross pattern.
-
❱❘ Clutch casing
- Verify whether the two centring bushings are
indeed well installed.
- Introduce the casing joint and hold it in place
with a bit of lubricant.
- Stick the water pump set ring [2] with a bit of
lubricant.
- Present the clutch casing while ensuring that the
water pump assembly has been properly
installed. The connecting rod assembly needs
to be rotated so that the water pump can mesh
at the end of the crankshaft.
- Install the M6 hex sprocket screws and tighten
to 10 N-m.
CAUTION
Install a new joint on the M6 x 40 screw and on the
coolant drainage screw.
Verify that all shafts rotate without encountering
any hard point.
36
125 SE-
R
1
2