Reed Valves And Intake Manifold; Transmission Output Sprocket; Mounting The Starter Drive - SHERCO 250 SE-R 2017 Workshop Manual

REASSEMBLY THE ENGINE
❱❘ Reed valves and intake manifold
- Install a new gasket between the reed valve
block and the intake manifold.
- Install the reed block on the intake manifold.
- Install a new gasket on the intake manifold
assembly.
- Attach the intake manifold assembly to the
engine using 4 M6 screws.
- Install the inlet sleeve with its metal collar.
❱❘ Transmission output sprocket
- Lubricate the O-ring and install it on the output
shaft.
- Slide the spacer over the output shaft so that it
engages the seal.
- Install the transmission output sprocket.
- Apply blue thread locker to the threads of the
output shaft.
- Install the safety washer.
- Install the nut and tighten to 150Nm.
- Bend the safety washer tab to retain the nut.
❱❘ Mounting the starter drive
- Install the double gear in the needle bearing.
- Install the starter drive.
- Install the triangle shaped retaining bracket
and the 3 shoulder bolts.
- Grease the gears with a spray lubricant.
42
250-300 SE-R