Removing The Electric Starter; Removing The Primary Drive Gear - SHERCO 250 SE-R 2017 Workshop Manual

DISASSEMBLY OF THE ENGINE
- Remove the pressure plate and the discs.
- Remove the clutch release bearing assembly
[1] located in the primary shaft.
❱❘ Removing the electric starter
- Remove the 2 screws [2].
❱❘ Removing the primary drive gear
- Secure the end of the crankshaft gear with the
special tool 5206 [3].
- Loosen the fi xing nut [4] and remove the nut,
primary drive gear and the conical washer.
- Open the safety washer on the clutch hub nut
[5].
- Use special tool 5749 [6] to hold the clutch hub
and loosen the nut.
- Remove the tool.
- Remove the nut, the clutch hub and the two
needle bearings.
18
3
6
250-300 SE-R
1
2
2
4
5