Clutch Discs, Pressure Plate; Clutch Housing - SHERCO 250 SE-R Workshop Manual

Reassembling the engine
❱❘ Clutch discs, pressure plate
- Apply oil to the clutch release bearing assembly
[1] and install in the primary shaft.
- Prior to installation lubricate the friction discs.
- Install a friction disc and then alternate, friction/
steel until 8 friction and 7 steel discs are installed.
- Install the pressure plate, the spring cups, the
springs and the screws.
- Tighten the screws to 10Nm using a cross pattern
for tightening.
❱❘ Clutch housing
- Check to make sure that the two locating dowels
are in place in the housing.
- Install the housing gasket and retain it with a little
grease.
- Install the water pump shim washers [2] use a
little grease to retain them.
- Install the clutch housing, make sure that the
water pump drive gear engages the crankshaft
gear; you may have to rotate the gear to get it to
engage.
- Install the M6 screws and tighten to10Nm, except
for the M6X12 which is tightened to 6Nm.
CAUTION
Install a new gasket on the M6X50 drain plug screw
as well as the M6X12 screws.
- Check to make sure that everything turns smoothly.
36
1
250-300 SE-R
2