Emerson Rosemount 2051 Series Quick Start Manual page 6

Quick Start Guide
Figure 6. Common Transmitter Assemblies
A.
4 x 1.75-in. (44 mm)
B.
4 x 2.88-in. (73 mm)
A. Transmitter with Coplanar Flange
B. Transmitter with Coplanar Flange and optional Flange Adapters
C. Transmitter with Traditional Flange and optional Flange Adapters
D. Transmitter with Coplanar Flange and optional Manifold and Flange Adapters
Bolts are typically carbon steel or stainless steel. Confirm the material by viewing
the markings on the head of the bolt and referencing
not shown in
representative for more information.
Use the following bolt installation procedure:
1. Carbon steel bolts do not require lubrication and the stainless steel bolts are
coated with a lubricant to ease installation. However, no additional lubricant
should be applied when installing either type of bolt.
2. Finger-tighten the bolts.
3. Torque the bolts to the initial torque value using a crossing pattern. See
for initial torque value.
Figure 2
4. Torque the bolts to the final torque value using the same crossing pattern. See
for final torque value.
Figure 2
5. Verify that the flange bolts are protruding through the isolator plate before
applying pressure.
6
C.
4 x 1.75-in.
(44 mm)
, contact the local Emerson Process Management
Table 2
D.
4 x 2.25-in.
(57 mm)
4 x 1.75-in.
(44 mm)
4 x 1.75-in. (44 mm)
. If bolt material is
Table 2
May 2013