Lauda Integral XT 150 Operating Instructions Manual page 104

Status
Setpoint
Identification
Actual Parameters
Pump Menu
Status
Setpoint
Identification
Actual Parameters
Pump Menu
Status
Setpoint
Identification
Actual Parameters
Pump Menu
102
30,00°C
End T T
set
intern
intern + extern
End T T
set
Store in Set 9
End T T
set
Starting up
-
With the menu
perature for the test run can be set.
The bath temperature will oscillate less
than about ±15 Kelvin around the set
temperature.
-
Change the display in the adjacent
window and accept with
fix
-
With the menu
timal control parameters for internal
control or for the internal control and
the external control can be detected
automatically.
To detect the control parameters for
the external application, a temperature
probe must be connected to the ther-
mostat.
fix
-
With the menu
actual set control parameters can be
stored in parameter set 9.
After the test run the detected control
parameters will be taken over as con-
trol parameters automatically. If the pa-
rameters found do not fulfil your expec-
tations, the before set parameters can
be restored (þ 7.15.5).
fix
Integral XT
Setpoint the set tem-
.
Identification the op-
Actual Parameters the
YAWE0028 / 24/06/2016