Removing And Replacing The Camera Assembly - Motorola V600 Service Manual

Disassembly

Removing and Replacing the Camera Assembly

38
1. Remove the battery cover, battery, SIM, antenna, rear housing, transceiver
board assembly, flip assmbly, and flip CLI lens assembly as described in the
procedures.
2. Use the tweezers to remove the two flip cover latches on each side of the flip
assembly (see Figure 15).
3. Remove the CLI Support frame and display assembly snubber.
4. Unlock and remove the camera assembly flex connector.
5. Use the disassembly tool to gently pry the camera assembly out of it's space in
the flip assembly.
Display Assembly
Snubber
Figure 15. Camera Assembly Removal
6. To replace, carefully press the camera assembly into its slot in the flip
assembly.
7. Insert the end of the camera assembly flex cable into its slot in the zif connector
on the flip display assembly.
8. Replace the flip CLI lens assembly, flip assembly, antenna, SIM, battery, and
battery cover as described in the procedures.
October 10, 2003
Support Frame
Disassembly Tool
Camera Assembly
CLI
Flip Cover
Latches
Flip Assembly
Camera Assembly
Flex Connector
6809468A79-O
V600