Motorola V600 Service Manual page 27

Level 1 and 2 Service Manual
G
6809468A79-O
3. Using the disassembly tool, release the housing latch on each side of the phone
as shown in Figure 6.
Rear Housing
Rear Housing Latch
Figure 6. Removing the rear housing
4. Carefully lift the rear housing away from the front housing and flip assembly.
The flip assembly and the front housing can also be removed at this point in the
disassembly procedure.
5. To replace, carefully align the rear housing to the front housing and the flip
assembly, then press the rear chassis assembly down until the 2 housing
catches engage with the corresponding openings on the rear chassis assembly.
Press the housings together until the catches snap into place.
6. Replace the 4 transceiver screws and tighten to a torque setting of 1.5 inch
pounds. Do not over tighten.
7. Replace the antenna, SIM, battery, and battery cover as described in the
procedures.
October 10, 2003
Disassembly Tool
Disassembly
031638o
27