Lap-Shoulder Belt Installation - Britax ROUNDABOUT User Manual

BRITAX Child Safety, Inc.

Lap-Shoulder Belt Installation

1. Remove the tether from
the pouch and place it
up and over the child
seat back.
2. Adjust this child seat to
position 1 or 2 and place
forward-facing on the
vehicle seat (see page 25).
Ensure that no more than
20% or 3 in. (7.6 cm) of the
base hangs over the edge
of the vehicle seat.
IMPORTANT:
seat may not perform as
intended if the base of the
child seat is not flat on the
vehicle seat.
3. Loosen the harness.
a. Lift harness adjuster
b. Remove the infant
4. Pull the seat cover
forward to access the
forward-facing belt path.
5. Open the green lock-off
closest to where the vehicle
belt will be buckled.
a. Open the locking tab.
b. Open the clamp.
6. Route the vehicle belt
through the forward-facing
belt slots, ensuring the
vehicle belt is not twisted,
then buckle.
7. Push down into the rear
of the child seating area
with moderate force while
removing all slack from
the bottom (lap) part of the
vehicle belt and close the
lock-off.
IMPORTANT:
vehicle lap and shoulder
belts must be routed
through the lock-off.
16
Roundabout G4_1.indb 16
Your child
lever and pull both
harness straps
forward.
positioning pillow
and unbuckle the
harness.
Both the
3"
Locking
5a
Tab
Clamp
5b
9/23/2014 8:43:37 AM