Task Selection; Task Key; Using Task Functions; Set Units - GE Druck DPI 610 User Manual

Task Selection

Task Key

The TASK key is used to set-up the instrument for a number of specific types of test.
There are two modes BASIC and ADVANCED and nine other specific types of test which
automatically configure the instrument on selection from the TASK menu. The tasks
available under the TASK menu are held on three pages shown below. To select a task
from the menu, press the TASK key, position the cursor over the required task and press
the ENTER key as shown below. Use the right/left cursor keys to switch between pages.

Using TASK Functions

Specific tasks are selected as shown above. The following diagrams show how to
connect the unit under test (UUT) for each task selectable under the TASK menu.
Input and output units, where applicable, can be selected by pressing either the INPUT or
OUTPUT keys as shown below.

Set Units

Note: If the four units displayed are not the units required, press SETUP, select SETTINGS
and refer to select regular units on page 37.
K0430 Issue No. 2 10