Cal Mode (Dpi 615 Instruments Only); Basic Mode (Task Basic) - GE Druck DPI 610 User Manual

Task Selection
Cal Mode (DPI 615 versions only)
Cal mode, which is available in tasks P-I, P-P, P-V, P-P, P-DISPLAY and P-SWITCH, provides
a method of setting up test parameters manually. Downloaded test procedures can also
automatically set up and turn on the Cal Mode function. The method of turning on and
setting up Cal Mode is shown below for a P-I task. A similar method can be used for all
the other tasks applicable to the Cal Mode function.
..........
TASK : P-I 24V OFF
DATALOG
TURN ON
CAL MODE
Pressing the F1 key (TURN ON CAL MODE), provides the set-up screen for the CAL mode.
Initially, the cursor is placed in the UUT SPAN field to allow the required span range to be
entered. The corresponding values for the UUT output parameter (current) are then set,
followed by the maximum error value and error type (%rdg or % span). When all test
parameters have been set-up, the screen changes to display the input and output and
the test results. The test result can only be displayed to within a range of ±9.99%. If the
test result is outside this range, either the left pointing (-ve error) or right pointing (+ve
error) chevrons are displayed. Within this error band, the actual tolerance value is
displayed. Test results can either be stored as snapshots or logged as data log files,
depending on how the instrument has been set-up.

Basic Mode (Task BASIC)

This instrument will power-up in this mode the first time that it is used. To select BASIC
from any other task, press the TASK key and select BASIC and press the ENTER key.
BASIC mode is fully described in the Getting Started, section (see page 7).
P
psi
0.00
=
2000.00
=
mA
OUTPUT
=
MAX. ERROR
=
ERROR TYPE =
psi
CHANGE
VALUE
I SELECT VALUE
mA
4.00
20.00
LINEAR
0.05%
% span
11
..........
TASK : P-I
24V OFF
DATALOG
mA
. %span FAIL
psi
TURN OFF
CAL MODE
K0430 Issue No. 2