Ping
1.
Ping Address
2.
Ping Count
3.
Start Pinging
4.
Main Menu
Figure 28. Ping Menu
3.9
Restore Defaults
Use the Restore Defaults option to restore all configurable settings to factory defaults except this
network information:
•
IP Address (Network)
•
Gateway Address
•
Subnet Mask
•
SLIP Address
To restore the system defaults, follow these steps:
1. From the Main Menu, type 6, Restore Defaults, and press <Enter>. See Figures 7 and 29.
2. At the prompt, type Y and press <Enter>. The defaults are restored.
1. System
2. Switch Configuration
3. Port Information
4. Reports
+---------------------------------------------+
| Restore Defaults.
+---------------------------------------------+
8. Logout
Figure 29. Restore Defaults Option
3.10 Restart Unit
If you download firmware, you must restart the 9135 to run the new firmware. Restart Unit, on the
Main Menu, interrupts the data transmission on all ports.
To restore the system defaults, follow these steps:
1. From the Main Menu, type 7, Restart Unit, and press <Enter>. See Figures 7 and 30.
2. At the prompt, type Y and press <Enter>. The 9135 restarts.
3-20
EdgeAccess Universal Chassis System
Restore Defaults
Are you sure?
Model 9135 10/100/1000
(Y/N) :
|