Table of Contents
Advertisement
Chapter 3
Management
Configure the 9135 through the management software. For your first session, you must use
HyperTerminal; you can set up Telnet access through the Host Table/SNMP Settings menu.
3.1
Set Up the Serial Port
The first time you access the 9135, use a terminal port connection and HyperTerminal on your PC.
These steps briefly describe how to set up your PC for a terminal connection. For details on using
Windows, see your Windows documentation.
1. Locate the Media Access Control (MAC) address label on the rear panel of the 9135 and record
the address.
2. Connect a straight through serial cable between the Terminal connector on the 9135 and COM1
or COM2 on your PC.
3. Turn on your PC and the 9135.
4. When the Windows desktop appears, click Start, then highlight Programs, Accessories, the
HyperTerminal Folder, and then click HyperTerminal.
5. At the Connection Description dialog, select an icon, enter a name for the connection to the
system, and click OK.
6. At the Connect To dialog, pull down the Connect using menu, select the COM port, and
click OK.
7. At the COM Properties dialog, on the Port Settings tab, set these values:
•
Bits per second: 9600
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
8. Click OK. HyperTerminal connects to the system and the VT100 terminal emulation starts.
3.2
Management User Interface
The Management User Interface for the 9135 provides screens for setup, monitoring, and diagnostics.
These sections discuss the screens for the 9135, using a Telnet session for access.
A typical screen, shown in Figure 5, includes standard descriptions and reference designations. Use
this and other screens to configure the system, set operational parameters, and verify the system
status. All screens use a common method for navigation.
EdgeAccess Universal Chassis System
Model 9135 10/100/1000
3-1
Advertisement
Table of Contents
