Slip Port Settings; Figure 10. Host Table / Snmp Settings Menu - Canoga Perkins EdgeAccess 9135 SNMP User Manual

IP Address
1. 172.16.142.1
2. 172.16.142.4
3. 172.16.142.3
4. 192.0.0.3
5. 0.0.0.0
6. 0.0.0.0
7. 0.0.0.0
8. 0.0.0.0

Figure 10. Host Table / SNMP Settings Menu

3.4.3 SLIP Port Settings

Serial Line Internet Protocol (SLIP) mode runs point-to-point and does not display messages on-
screen. Only those IP packets addressed to the SLIP IP address receive a response. The SLIP IP
address must be on a different network than the Ethernet IP address. The SLIP subnet mask is
assumed from the Class type of the IP address and does not allow a default gateway. The SLIP IP
address is saved in non-volatile RAM.
To set up SLIP mode, see Figure 11 and Table 10 and follow these steps:
1. From the System menu, type 3, SLIP Settings, and press <Enter>.
2. At the SLIP Port Settings menu, type 6, SLIP IP Address, and press <Enter>.
3. At the prompt, enter the IP address, then type Y to confirm it and save it.
4. Set values for other parameters as needed; see Table 10.
When you start SLIP mode from your PC, the serial port runs in SLIP mode until it receives a series
of three carriage returns or you reset the SNMP module. For details, see Chapter 4.
EdgeAccess Universal Chassis System
HOST Table/SNMP Settings
SNMP Access
Access
SNMP only read/write/trap public
SNMP only read/write/trap public
SNMP only read/write/trap public
SNMP only read/write/trap public
SNMP only read only
SNMP only read only
SNMP only read only
SNMP only read only
9. Read Community
10. Write Community
11. Send Alert Traps
12. Send Auth Traps
13. Disable Traps From
14. Enable Telnet Security : no
15. Main Menu
Model 9135 10/100/1000
Trap
Level Community
: public
: private
: yes
: yes
: none
Trap
Port
162
163
162
162
162
162
162
162
3-7