Performing Testing On Unplanned Test Points; Performing An Unplanned Atp Test; Performing An Unplanned Visual Inspection Test - 3M LM1 User Manual

PERFORMING TESTING ON UNPLANNED TEST POINTS

Performing an Unplanned ATP Test

1. Tap [Unplanned Test]
To start a new run, tap [New Test Run...].
• Or, if you are restarting a run of unplanned tests that you did not complete, tap the starting date and time you
want to restart.
2. Tap Select Test Type
• UXL100(Surface ATP)
• AQF100
• AQT200(water total)
3. Tap [OK].
4. Follow the Instructions for Use for the 3M Clean-Trace Test to collect a sample, activate the test and shake it for at least
5 seconds.
5. Open the 3M Clean-Trace Luminometer by pressing the rocker cap. Then insert the activated test into the chamber.
Keep the 3M Clean-Trace Luminometer upright whenever a test is in the chamber, to ensure accurate results and avoid
spillage of reagents, which could damage the sensitive components of the instrument.
6. Tap [Start] to begin measuring. A progress bar
and is stored in the memory so it can be synchronized with the 3M Clean-Trace Hygiene Management Software.
7. To remove the test from the 3M Clean-Trace Luminometer, press the rocker cap, grasp the top of the test and pull
upwards. Follow the instructions for disposal in the 3M Clean-Trace Test Instructions for Use.
8. To do another unplanned ATP test, tap [New] and repeat this process.
• Or, to do a retest, tap [Retest]

Performing an Unplanned Visual Inspection Test

1. Tap [Unplanned Test]
2. To start a new run, tap [New Test Run...].
Or, if you are restarting a run of unplanned tests that you did not complete, tap the starting date and time you want
to restart.
• If a starting date and time does not appear, tap scroll up
display additional Sample Plans.
3. Tap Select Test Type
4. Tap [OK].
5. Tap [PASS] for a Pass result or tap [FAIL] for a Fail result.
6. If you selected Pass, the Pass
symbol appears and [Retest]
7. To do another Visual Inspection test, tap [New].
• To add a comment, tap Add Comment
appear. Tap [Add Comments], then tap the comment to add. Tap [OK]. Tap [Back].
• If you decide not to add a comment, tap [Back]
.
then tap the test type:
then tap [Start]
.
then tap [Visual Inspection].
display appears. If you entered Fail, the Fail
appears.
. The Add Comments screen and any previously added comments
appears and moves from left to right. The test result appears
.
or scroll down
display appears, and the add comment
to return to the previous screen.
13
EN
(English)
or swipe the list up or down to