Leica GS15 User Manual page 39

Fixing the Field
Controller and
GHT66 to a Pole
Step-by-step
Detaching the Field
Controller from a
Pole Step-by-step
GS10/GS15, Operation
Step Description

For an aluminium pole, fit the plastic sleeve to the pole clamp.
1. Insert the pole into the clamp hole.
2. Attach the holder to the clamp using the clamp bolt.
3. Adjust the angle and the height of the holder on the pole to a comfortable
position.
4. Tighten the clamp with the clamp bolt.
5. Before placing the CS field
controller onto the mounting
plate, ensure that the locking pin
is put into the unlocked position.
To unlock the locking pin, push
the locking pin to the left.
6. Hold the CS field controller above the holder and lower the end of the CS
field controller into the mounting plate.
7. Apply slight pressure in a downward direction and then
lower the top part of the CS field controller until the unit
is clicked into the holder. The guides of the mounting
plate aid in this action.
8. After the CS field controller is
placed onto the mounting plate,
ensure that the locking pin is put
into the locked position. To lock
the locking pin, push the locking
pin to the right.
Step Description
1. Unlock the locking pin by pushing the locking pin to the left of the mounting
plate.
2. Place your palm over the top of the field controller.
3. While in this position, lift the top of the field controller
from the holder.
008546_001
008549_001
7b
7c
7a
008547_001
1
2
3
008551_001
39