Leica GS15 User Manual page 32

Equipment setup
step-by-step
GS10/GS15, Operation
Step Description
1. Set up the tripod.
2. Mount and level the tribrach on the tripod.
3. Ensure that the tribrach is over the marker.
4. Place and lock the carrier in the tribrach.
GS10
5. Screw the GNSS antenna onto the
carrier.
6. Check that the tribrach is still level.
7. Insert the data storage device and the
batteries into the instrument.
8. Connect the instrument to the GNSS
antenna using the antenna cable and
port ANT on the instrument.
9. Connect the field controller to the
instrument if necessary.
10. To hang the instrument on the tripod
leg, use the hook on the rear of the
unit. Or place the instrument in the
container.
11. Insert the height hook into the
carrier.
12. Measure the antenna height using the
height hook.
13. Clip the antenna arm to the GNSS
antenna.
14. Screw the radio antenna onto the
antenna arm.
15. Attach the radio in its housing to port
P2 or P3 on the instrument.
16. Connect the radio antenna to the
radio using the second 1.2 m antenna
cable.
17. Press the ON/OFF button on the
instrument for at least 2 s to switch
on the instrument.
GS15
Insert the data storage device and
the batteries into the GS15.
Press the ON/OFF button on the
instrument for at least 2 s to switch
on the instrument.
Screw the GS15 onto the carrier.
Check that the tribrach is still level.
Insert the data storage device and
the battery into the field controller.
Connect the field controller to the
instrument if necessary.
To hang the field controller on the
tripod leg, use the hook on the hand
strap or use the utility hook. Refer to
the User Manual of the field
controller.
Insert the height hook into the
carrier.
Measure the antenna height using
the height hook.
Press the ON/OFF button on the
instrument for at least 2 s to switch
on the instrument.
-
-
-
32