Panasonic SF4B-F31G(V2) Instruction Manual page 61

Setting procedure and
check items
Open the emission
halt input / Reset
output.
Receiver's control
3
output (OSSD 1 / 2)
is OFF.
(Emission halt)
(Normal operation)
Connect the emis-
sion halt input to Vs.
(Note 3)
4 Receiver's control
output (OSSD 1 / 2)
is ON.
(Normal operation)
Notes: 1) Since the color of the operation indicator changes according to the ON / OFF state of the control output
(OSSD 1 / 2), the operation indicator is marked as "OSSD" on the device.
2) The status of the emitter / receiver indicators during operation above shows the case in PNP output
setting mode. In case of NPN output setting mode, the NPN indicator (orange) lights up.
3) Vs is the applying supply voltage.
© Panasonic Industrial Devices SUNX Co., Ltd. 2017
: Blinks in
orange
Emitter
Beam-axis alignment
indicator
Operation indicator (Red) (Note 1)
Incident light intensity indicator
Fault indicator
Digital error indicator
PNP indicator (Orange) (Note 2)
NPN indicator
Emission intensity control indicator
Emission halt indicator (Orange)
Beam-axis alignment
indicator (Green)
Operation indicator
(Green) (Note 1)
Incident light intensity indicator
(Green)
Fault indicator
Digital error indicator
PNP indicator (Orange) (Note 2)
NPN indicator
Emission intensity control indicator
Emission halt indicator
: Lights up : Lights up
in red in green
Indicators
Receiver
Beam-axis alignment
indicator
OSSD indicator (Red)
Incident light intensity indicator
Fault indicator
Digital error indicator
PNP indicator (Orange) (Note 2)
NPN indicator
Function setting indicator
Interlock indicator
Beam-axis alignment
indicator (Green)
OSSD indicator (Green)
Incident light intensity indicator
(Green)
Fault indicator
Digital error indicator
PNP indicator (Orange) (Note 2)
NPN indicator
Function setting indicator
Interlock indicator
: Lights up : Turns
in orange OFF
Control output
OSSD 1 OSSD 2
OFF
ON
61